Skip Headers
Oracle® Database Vault Installation Guide
10g Release 2 (10.2) for Solaris Operating System (SPARC 64-Bit)

Part Number B31294-03
Go to Documentation Home
Home
Go to Book List
Book List
Go to Table of Contents
Contents
Go to Index
Index
Go to Master Index
Master Index
Go to Feedback page
Contact Us

Go to previous page
Previous
Go to next page
Next
View PDF

A How to Stop Processes in an Existing Oracle Real Application Clusters Database

This appendix describes how to stop all processes in an Oracle Real Application Clusters (RAC) database, in preparation for installing Database Vault.

Note:

Before you make any changes to the Oracle software, Oracle recommends that you create a backup of the Oracle Database installation.

Shut down the following Oracle Database services before modifying the Oracle Database software:

Note:

You must perform these steps in the order listed.
  1. Shut down any processes in the Oracle home on each node that can access a database. For example, you need to shut down Oracle Enterprise Manager Database Control.

    $ORACLE_HOME/bin/emctl stop dbconsole
    
    

    Note:

    Before you shut down any processes that are monitored by Enterprise Manager Grid Control, set a blackout in Grid Control for the processes that you intend to shut down. This is necessary so that the availability records for these processes indicate that the shutdown was planned downtime, rather than an unplanned system outage.
  2. Shut down all RAC instances on all nodes. To shut down all RAC instances for a database, enter the following command, where db_name is the name of the database:

    $ oracle_home/bin/srvctl stop database -d db_name -c "SYS/password AS SYSDBA"
    
    
  3. Stop all node applications on all nodes. To stop node applications running on a node, enter the following command, where node is the name of the node where the applications are running:

    $ oracle_home/bin/srvctl stop nodeapps -n node -c "SYS/password AS SYSDBA"